Generation
AirDeck Something, something guide
Introduction
Installers should adhere to all current Health and Safety Rules, such as the wearing of protective clothing, ie hard hat, high visibility Vest/Jacket, metal toe capped boots and hand protective gloves. AirDeck products are tested to the requirements of PAS59 safety standard.
1:
Ensure the area is free from debris. Layout the AirDeck bags to allow for complete floor coverage. One bag when inflated measures 750mm x 750mm x2100mm (WxHxD) and covers 1.6 m2. 50 bags, for example, will cover 80m2.
2:
Make sure that the inflator is ready for use and that the battery is fully charged. Three green lights on the charger indicate that the battery is charged to its maximum.
3:
Open the access flap and expose the valve. Remove the screw cap.
4:
Insert the Inflator through the valve and inflate with the Inflator at maximum.
5:
Fully inflate the liner until it completely fills the outer. The pressure regulator on the blower will ensure that the AirDeck is not overinflated.
6:
Once the liner is full of air, make sure the non-return flap is well seated, and then screw the cap on tightly.
7:
On full inflation of the AirDeck, make sure that the liner does not protrude and that the flap will close fully to protect the liner.
8:
Should this not be the case, deflate the liner slightly and adjust by pulling the liner through the access overlap flap at the far end of the liner.
9:
Add more bags by following Steps 1-7 and clip them together. If the bags are not constrained by outer walls and are being used in an open situation, use bags with clips both top and bottom to ensure no movement of the bags
10:
Cover the whole floor area. Clip the last bag in the row to its neighbour before inflating further bags. If necessary, partly inflated bags can be squeezed into small or awkward gaps.
11:
To deflate the bags remove the valve screw cap. Push back the flap using the red tab until it locks in position. Using the extract facility on the pump, if it has one, draw out all the air. Alternatively, the bags will deflate rapidly if the valve is just left open.
12:
Make sure the bags are fully deflated and then fold for on-site storage. Take care to store the bags and liners in a protected environment
Branches
4 Westerton Road,
East Mains Industrial Estate, Broxburn,
West Lothian, EH52 5AU
T: 01506 863 864 F: 01506 863 916
Unit H, Hangman’s Wood Ind Park,
Stifford Road, South Ockendon,
Essex, RM15 6RL
T: 020 7473 6056 F: 01708 858 493
Forward House, Portobello Road
Portobello Industrial Estate, Birtley,
Tyne and Wear, DH3 2SN
T: 0191 492 1190 F: 0191 411 1148
Unit 4 Vauxhall Industrial Estate,
Greg Street, Reddish,
Stockport, SK5 7BR
T: 0161 477 0131 F: 0161 477 7618
Unit 20B Greens Industrial Park,
Calder Vale Road, Wakefield, WF1 5PH
Trinity Street, Off Tat Bank Road
Oldbury, West Midlands, B69 4LA